Nail through flashing into shingle do not extend flashing above top of shingle and.
Roof step flashing installation.
Once you ve shingled up to the sidewall cut a piece of step flashing at a 45ยบ angle from the outside corner to the bent seam.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
Cover tops of step.
Install the step flashing when the siding is installed it should be tucked behind this piece and then consecutive courses lapped over it.
Typically flashing is installed using roofing nails and roofing cement.
Proper installation of step flashing.
Step flashing step flashing redirects the water back onto the shingle.
Nail flashing to roof deck only.
Then sink two nails in the wall near the top one on each face.
In order to properly install new flashing you ll have to remove the shingles surrounding your old flashing and then re lay them after installation.
Bend it down and back to sit flat on the corner.
Bend it back so that it overlaps the corner flashing.
Hammer one nail to the.
Nail it in place with two nails one.
The roof deck flange of step flashings are to be fastened to the surface of each shingle in a position whereby the next course of shingles will cover up hide the flashing from view.
Here s how to do it right the first time.
How to install step flashing with a wall corner step three.
Wide and 2 in.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
Lay a bead of sealant.
How to install roof flashing against a wall.
Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in.
Cut step flashing pieces to be 10 in.
Ensure it sits flat and extends at least 8 inches above the shingles.
Then set the piece down.