Therefore a 2 inch overlap provides redundancy at the edges where the barrier is weakest.
Roofing felt overlap size.
However you must allow for overlaps on joints.
If there is any wind at all roll out the felt only about 10 feet.
The vertical leg of the drip edge should be at least 1 5 inches wide and extend at least 0 25 inches below the sheathing.
Never walk on felt that has not been nailed down.
Roofing requirements roofing felt is required to overlap 2 inches over the lower felt course.
Pick up the roll with both hands.
One roll of conventional 15 felt covers 432 square feet 40 1 m 2.
Continue along the roof to the other end and trim the felt flush at the end with a utility knife.
In steep slope roofs 4 12 and steeper the upper courses of felt underlayment should overlap lower courses by at least 2 inches.
The overlapping felt creates a secondary barrier for moisture and wicks water away from the shingles above and the sheathing below.
Purchase enough felt to cover your roof s area.
Convert the area from inches to feet prior to purchasing your felt.
You can see the difference between the underlayment overlapped 19 inches on the roof to the right and overlapped 2 inches on the roof to the left.
The drip edge should extend at least 2 inches on the roof.
Overlap the end of a roll about 4 inches with the start of a new roll and fasten both pieces to the.
Roll out the felt no more than midway perhaps 25 feet or so across the average size roof.