Tack Strip Between Carpet And Wood Floor

Once you have all of the tack strips up it is time to remove any staples on the floor from the carpet pad.

Tack strip between carpet and wood floor.

I love using the wonder tool and these pliers for this job. Designed to eliminate your carpet edges from fraying vinyl floor edging from curling. Fasten the pad to the wood subfloor with staples every 10 12 in each direction. This video will show a carpet transition turn n tack method the correct way to get great results while roll and staple carpet.

Make quick work of creating a smooth transition between two different flooring surfaces with help from trafficmaster. Work toward the tack strips smoothing the pad and stapling. Typically there will be three nails spaced evenly along each three foot section of tack strip. A lot of times i can just use the pliers to get the staples up but some staples are so close to the floor that i need to use the wonder tool to get them started.

A hammer stapler can speed up this process. Locate the brad nails that hold the first piece of tack strip to the floor. Cut a strip of carpet reducer to the length you measured using a chop saw. Staple the pad against the edge of the tack strip.

Connect a gap in your flooring or cover connect a gap in your flooring or cover up a seam with the exclusive silver fluted carpet trim from trafficmaster. For thinner carpet you may want to place it closer and vice versa for thicker carpeting. Concrete tack strip uses hardened steel nails that can penetrate concrete. Step 3 place the curved edge of a small pry bar against the tack strip lining the pry bar up with the first nail.

Hold it in position over the gap between the carpet and the hardwood flooring while you center the trim track underneath. This will allow an approximate 1 4 inch gap between. Run a carpet knife against the strip to trim the pad. If padding over a concrete floor use adhesive.